Siemens SINUMERIK 840D sl Function Manual page 456
Sinumerik safety integrated
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
Diagnostics
10.3 Safety messages for SINAMICS S120
Remedy
F01660
Response:
Acknowledgement
Explanation
Remedy
F01670
Response:
Acknowledgement
Explanation
10-456
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) – 03.2006 Edition
12:
An attempt was made to enable the SBC function although this cannot
be supported for a parallel circuit configuration.
13:
An attempt was made to enable the safe motion monitoring with the
higher-level control although this cannot be supported.
See also: p0970, p3900, r9771, r9871
Re fault value = 1:
– Set the Safety Integrated password (p9761).
Re fault value = 2:
– Inhibit Safety Integrated and again reset the drive parameters.
Re fault value = 3:
– Simulation mode for the digital input ended (p0795).
Re fault value = 10, 11, 12, 13:
– Check whether there are faults in the safety function alignment
between the Control Unit and the Motor Module involved (F01655,
F30655) and if required, carry-out diagnostics for the faults involved.
– Use a Motor Module that supports the function "safe standstill" or
"safe brake control".
– Upgrade the Motor Module software.
– Upgrade the Control Unit software.
See also: p9501, p9601, p9761, p9801
SI CU: Safety-related functions not supported
OFF2
IMMEDIATELY (POWER ON)
The Motor Module (MM) does not support the safety-related functions
(e.g. the Motor Module version is not the correct one). Safety
Integrated cannot be commissioned.
Note:
This fault results in a STOP A that cannot be acknowledged.
Use a Motor Module that supports the safety-related functions.
– Upgrade the Motor Module software.
SI motion: Invalid Sensor Module parameterization
OFF2
IMMEDIATELY (POWER ON)
The parameterization of a Sensor Module used for Safety Integrated is
not permissible.
Note:
This fault results in a STOP A that cannot be acknowledged.
Fault value (r0949, decimal):
© Siemens AG, 2006. All rights reserved
03.06
Advertisement
Chapters
Table of Contents
