Siemens SINUMERIK 840D sl Function Manual page 383
Sinumerik safety integrated
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
03.06
The vertical "Bit selection trace 1...", "Bit selection trace 2...", "Bit selection trace
3..." and "Bit selection trace 4..." softkeys provided allow, for the SI signals se-
lected in trace channels trace 1 to trace 4, bit names of these SI signals to be as-
signed a possible 10 character channels (tracks) in the bit graphics for these sig-
nals. A dedicated graphic is displayed for trace 1, trace 2, trace 3 and trace 4.
If a bit-coded SI signal is not selected in a trace channel, then when the corre-
sponding softkey is pressed, it has no effect; information is output in the dialog line
to signal that it does not involve a bit-coded SI signal.
Bit selection, trace 1...
In the example, the signal SGE-NCK has been read-in to graphic 1 for trace 1. The
following screen is displayed when the vertical "Bit selection trace 1..." softkey is
pressed:
The bits of this signal are consecutively numbered. Every bit is permanently as-
signed an associated bit name. In the input box "track", by assigning a value in the
range between 0..9 it is possible to define in which of the 10 character channels
(tracks) the bit should be graphically displayed. In the example, for trace 1, bit 0
SBH/SD de-selection NCK is displayed in track 0 of the bit graphic. Bit 19 de-
selection ext. Stop C NCK is displayed in track 9 of the bit graphic for trace 1.
© Siemens AG, 2006. All rights reserved
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) – 03.2006 Edition
10.1 Troubleshooting procedure
Diagnostics
10-383
Advertisement
Chapters
Table of Contents
