Suzuki SQ416 Service Manual page 88
Hide thumbs
Also See for SQ416:
- Service manual (118 pages) ,
- Owner's manual (266 pages) ,
- Service manual (731 pages)
Table of Contents
Advertisement
2. Forward clutch
1. Planetary ring gear side
2. Forward clutch side
2. Cutout in automatic
transmission
14) Install forward clutch assembly by putting all lugs of direct
clutch disc hub together and matching them with groove cut in
direct clutch input hub, and at the same time aligning splines
in forward clutch hub with inner shaft.
NOTE:
Use care not to let forward clutch rear No.1 race and thrust
bearing installed to forward clutch hub fall off.
15) When clutch disc and plate have been replaced, check height
difference between forward clutch input shaft and transmission
case (1) by measuring as shown in the figure.
Standard height difference "a":
About 2.0 mm (0.079 in.)
NOTE:
If measured value is less than standard value, remove for-
ward clutch assembly and install it again.
16) Apply grease to thrust forward clutch bearing and install it to
forward clutch input shaft. Also apply grease to thrust rear race
and install it to O/D case.
17) Install O/D case by aligning cutout in O/D case (1) and that in
transmission case.
NOTE:
Use care not to drop thrust rear race installed to O/D case.
18) Apply grease to thrust planetary rear washer and install it to
O/D planetary gear. Also apply grease to thrust planetary ring
front race and install it to planetary ring gear and then install
O/D input shaft assembly to O/D case.
NOTE:
D Fit claws of thrust planetary rear washer and thrust plan-
etary ring front race into holes securely.
D Use care not to drop thrust planetary rear washer
installed to O/D planetary gear.
AUTOMATIC TRANSMISSION (4 A / T) 7B1-17
Hide quick links:
Advertisement
Chapters
Table of Contents
