Suzuki SQ416 Service Manual page 13
Hide thumbs
Also See for SQ416:
- Service manual (118 pages) ,
- Owner's manual (266 pages) ,
- Service manual (731 pages)
Table of Contents
Advertisement
"A"
1. Axle housing
(c)
5) Clean mating surfaces of axle housing and differential carrier
and apply sealant to housing side.
"A": Sealant 99000-31110
6) Install differential carrier assembly to axle housing and tighten
carrier nuts to specified torque.
Tightening Torque
.
(a): 55 N
m (5.5 kg-m, 40.0 lb-ft)
7) For vehicle with ABS, connect wheel speed sensor coupler and
install harness.
8) Install propeller shaft and torque nuts to specification.
Tightening Torque
.
(b): 50 N
m (5.0 kg-m, 36.5 lb-ft)
9) Remove floor jack from axle housing and connect breather
hose onto axle housing and clamp it securely.
10) Connect brake pipes onto axle housing and clamp them se-
curely.
For clamping positions, refer to SECTION 5A of this manual.
11) Connect brake flexible hose to bracket on axle housing and se-
cure it with E-ring.
12) Install LSPV stay to axle housing, tighten LSPV stay bolt to
specified torque.
And adjust LSPV referring to "LSPV ASSEMBLY INSPEC-
TION AND ADJUSTMENT" in SECTION 5A.
Tightening Torque
.
(c): 23 N
m (2.3 kg-m, 17.0 lb-ft)
13) Connect brake pipe to brake flexible hose and tighten brake
pipe flare nut to specified torque.
Tightening Torque
.
(d): 16 N
m (1.6 kg-m, 11.5 lb-ft)
REAR SUSPENSION 3E-5
Hide quick links:
Advertisement
Chapters
Table of Contents
