Suzuki SQ416 Service Manual page 87
Hide thumbs
Also See for SQ416:
- Service manual (118 pages) ,
- Owner's manual (266 pages) ,
- Service manual (731 pages)
Table of Contents
Advertisement
7B1-16 AUTOMATIC TRANSMISSION (4 A / T)
9) Using screwdriver with vinyl tape or the like wound at its tip,
install retaining reaction plate ring (1). After installation, check
that ring is in groove securely.
10) After confirming that lugs of all brake plates and brake discs are
in grooves securely, hold retaining direct clutch ring (1) of plan-
etary sun gear, install center support assembly by aligning fluid
holes (2) in center support and transmission case.
NOTE:
Unless retaining direct clutch ring of planetary sun gear is
held, brake valve gets off center support and that will make
it impossible to align fluid holes with bolt holes.
11) Tighten center support bolts by certain amount at a time till spe-
cified tightening torque is obtained.
Tightening torque
Center support bolt: 26 N
12) Install direct clutch assembly by aligning splines in direct clutch
cylinder with planetary sun gear.
NOTE:
Ends of splines in direct clutch cylinder and planetary sun
gear should come almost in match.
13) Apply grease to forward clutch rear No.1 race (1), thrust rear
bearing (2), thrust bearing rear planetary ring race (3) and
install thrust bearing planetary ring race (3) to direct clutch cyl-
inder and forward clutch rear No.1 race and thrust bearing to
forward clutch hub.
.
m (2.6 kg-m, 19.0 lb-ft)
Hide quick links:
Advertisement
Chapters
Table of Contents
