1. Selector cable
2. Manual selector assembly
3. Expanding selector cable clip
Type-1
1. Interlock cam pin
(only for new selector assembly)
(For Type-2)
1) Disconnect negative (–) cable at battery.
2) Remove console box.
3) Disconnect connector for illumination lamp, shift lock solenoid
(if equipped) and overdrive OFF switch.
4) Remove selector assembly mounting bolts.
5) Disconnect selector cable from manual selector assembly ex-
panding selector cable clip.
INSTALLATION
(For Type-1)
NOTE:
New selector assembly of Type-1 is supplied with held inter-
lock cam at interlock cable connecting position with pin. Re-
move this pin after connecting interlock cable to interlock cam
and tightening cable nut.
Reverse removal procedure to install noting the followings.
D Connect interlock cable end to cam referring to steps 2) to 8) of
"Interlock Cable Installation" section.
D Upon completion of installation, confirm that brake (key) interlock
system operates properly.
AUTOMATIC TRANSMISSION (4 A / T) 7B1-3