Stop Lamp Switch; Switch) Circuits Check - Suzuki SQ416 Service Manual
Hide thumbs
Also See for SQ416:
- Service manual (118 pages) ,
- Owner's manual (266 pages) ,
- Service manual (731 pages)
Table of Contents
Advertisement
8E-12 CRUISE CONTROL SYSTEM
STOP LAMP SWITCH (WITH PEDAL POSITION SWITCH) CIRCUITS CHECK
Step
1
Stop Lamp Switch (With Pedal Position Switch) Circuits Check
1) Disconnect connector from cruise control module with
ignition switch OFF.
2) Check for proper connection to cruise control module at
terminals E132-2 and E132-6.
3) If OK, turn ignition switch ON.
4) Check Voltage between each terminal and ground under
each condition below.
Stop lamp switch circuit specification
Brake pedal released terminal E132-2: 0 V
Brake pedal released terminal E132-6: 10 – 14 V
Brake pedal depressed terminal E132-2: 10 – 14 V
Brake pedal depressed terminal E132-6: 0 V
Is check result satisfactory?
2
Stop Lamp Switch Position Check
1) Check stop lamp switch for installation position referring to
"STOP LAMP SWITCH" in Section 5.
Is check result satisfactory?
3
Stop Lamp Switch (With Pedal Position Switch) Check
1) Disconnect connector from stop lamp switch.
2) Check for proper connection to stop lamp switch at all
terminals.
3) If OK, check stop lamp and pedal position switches for
operation referring to "STOP LAMP SWITCH" in this section.
Is this switch in good condition?
Fig. for Step 1
Action
Yes
Stop lamp switch
Go to Step 2.
(with pedal
position switch)
circuits are OK.
Go to Step 3.
Adjust.
"Y/G" or "G/W"
Replace.
circuit is open or
short.
No
Hide quick links:
Advertisement
Chapters
Table of Contents
