Table of Contents
Advertisement
Figure 79 Identifying the rollers
1
SP1 or DP1 steel roller with ends recessed
2
SP2 or DP2 rubber roller with a wide priming
surface
3
SP3 or DP3 steel roller
The installation for the inner and outer station rollers is similar. The order of the rollers installation is
as follows (refer to Figure 78 and Figure 63):
1st
Rubber roller SP4 or DP4
2nd
Rubber rollers SP2 and DP2
CAUTION:
Take care not to damage the priming surface of the
rubber rollers. They are very delicate and can be
damaged easily.
The rubber rollers should be supported by their
shafts either in their shipping box or in the ILP.
They should not be allowed to rest on a flat surface
(even for a short time) as damage will be caused to
the rollers surface.
CA294-03070 rev 00
4
SP4 or DP4 rubber roller with a narrow priming
surface
5
SP5 or DP5 steel roller
Installation Manual
page 98 of 153
- Quick Links:
- Installation Instruction Details
Hide quick links:
Advertisement
Table of Contents
