Pre-Installation Procedure; Verifying Site Preparation; Marking The Pressroom Floor For Press Components; Unpacking The Boxes - HP Indigo Division Series Instruction For Use & Installation Instructions

Table of Contents

Advertisement

Pre-installation procedure

Verifying site preparation

Verify that the pressroom has been equipped with the following per the HP Indigo press w3250 site
preparation guide:
Chiller input and output
Power for press
Air conditioning of work area
Fast Ethernet networking
Parts cleaning station
External densitometer
Lockable main switch
Electrical outlets installed near pluggable equipment and are easily accessible
The printing engines may be mounted on the u-bases on-site or off-site. Make sure that the entrance
to the site is large enough to allow an object 2200 mm high to enter.

Marking the pressroom floor for press components

1.
Open the installation kit and select the marking pen.
2.
Use the marking pen to mark the pressroom floor with the profile of the main press
components and indicate their placement. Refer to the HP Indigo press w3250 site
preparation guide for details of the floor area.

Unpacking the boxes

1.
Before opening the boxes, check that the shock and tilt sensors have not changed color to
red. If either of the sensors has changed color to red, then the boxes were mishandled. Notify
the Regional Service Manager or Installation Manager immediately.
2.
Unpack the box containing the accessories kit.
Open the accessories kit, and remove the System Information File.
Remove the customer letter about residual ink (P/N SV8-0039-00) from the System
Information File.
3.
Give the letter to the customer.
4.
The boxes are opened in the order of installation. At each stage of the installation open each
box carefully and inspect the part for damage before installing. If any part shows signs of
damage, immediately notify the Response Center or Regional Service Manger.
Verify the contents of each box according to the contents list included with the boxes.
5.
Notify the Regional Manager or Installation Manager regarding any installation problems or
damage found when unpacking the boxes.
CA294-03070 rev 00
Installation Manual
page 23 of 153

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

W3250

Table of Contents