Table of Contents
Advertisement
2.
Use Run no. 1 prints to evaluate the quality of 10 successive printed copies according to the
CATP described in "CATP specification checklist" on page 147.
All the tests should be related to Run no. 1. It is specified in the test if related to another run.
3.
Use Run no. 2 and its printed copies only when defined in the CATP test.
4.
Once the test is completed, file a copy of the printout in the press system log, along with the
writing head tests, etc.
Send another copy to the local RC for analysis.
NOTE:
Printing CATP test
If the CATP job passes the test, print 1000 duplex copies. During the print run, verify the following:
Print quality should be consistent.
No major malfunctions.
Check the entire fluid system for leaks.
CATP specification checklist
Item
Description
A
Max image area
Check that the black border is visible on all sides of the page. This frame is 1
point in thickness and represents the maximum printing area in the following
size:
-
Image outline frame width without eye
marks:
-
Image outline frame width with eye
marks:
-
Note:
Image printable area width 308 mm includes registration marks. For
the first presses, the image width with eye mark is smaller and equal to 308
mm. The mark width is determined by R & D with a target of 5 mm.
-
Measurements to be made approximately 30 minutes after printing the image.
-
Eye marks position verification
Leading edge mark f = 15 ± 0.5 mm
Trailing edge mark g = 445 ± 0.5 mm (for repeat length of 460 mm only)
Refer to Figure 111 on page on page 151.
C/B
Image placement (PE1 - side A only)
B
Refer to Figure 111 on page on page 151.
-
Repeat length = 460 ± 0.5 mm
(PE1 - side A only) between successive leading edge eye marks
Side position = 6 ± 0.5 mm (for paper width of 320 mm)
-
Distance from left edge of frame to web left edge (PE1 - side A only)
-
Skew = 0.5 mm
C/B-B
-
Measured by optic ruler
The reference master CATP job (printed by both printing
engines on a continuous web in the production line) is
included with each press.
308 ± 0.5 × 450 ± 0.5 mm
Measure on printed copies of run
no. 2
303 ± 0.5 × 450 ± 0.5 mm
CA294-03070 rev 00
Installation Manual
Pass/Fail/Waiver
-
-
-
-
-
-
-
-
-
-
-
page 147 of 153
- Quick Links:
- Installation Instruction Details
Hide quick links:
Advertisement
Table of Contents
