Table of Contents
Advertisement
Figure 29 Inserting the turnbar into the exit side of PE2
1
Notch for turnbar end roller shaft
2
Turnbar end roller shaft
1.
Mount the turnbar in the exit side of PE2.
The turnbar end roller shaft fits into the notches in the output assembly of the PE2 WHS
(Figure 29).
Mounting the PE1
At the PE1
1.
Repeat step 2. on page 33 for the PE1.
2.
Use a manual forklift to move the presses and u-bases to their fixed marked positions on the
floor
Make sure to move PE1 close to PE2, but leave a gap of at least 1 cm between the engines.
3.
Use an Allen M6 key to verify the tightness of the junction bar securing screws between PE1
and PE2 u-bases.
4.
Tighten all other securing screws of the two u-bases.
CA294-03070 rev 00
Installation Manual
page 45 of 153
- Quick Links:
- Installation Instruction Details
Hide quick links:
Advertisement
Table of Contents
