Create MyConfig - Topo
6.4 Topo - operation
DO type
Note
You can recognize which components are assigned to which DOs.
If you select a wired component, the remaining components that are assigned to the same DO
are highlighted.
Display of the DO variables
The properties of the DO variables assigned to a component are displayed in the "Properties"
dialog box.
Figure 6-5
6.4.3.1
Local DO list
As of Create MyConfig Version V4.7, local DO lists are used in Topo. This means that there
is a separate variable table for each topology of a project. In earlier CMC versions there was
a global list.
If the same variables are configured for different topologies or projects, it makes sense to link
an external list. In this way, you get the same behavior as in earlier CMC versions.
When importing archives, DO variables are automatically formed from the DO names. In the
version CNC V4.6 or higher, when commissioning with Create MyConfig, the DO variables are
saved in SINAMICS and are thus available again for the archive import.
372
Component type
Motor module
Motor
Sensor module
Encoder
Terminal Module
Terminal Board
Hub Module
NX10 or NX15
Component properties
Permitted number
1
1
2
2
1
1
2
1
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD