4.4.2.29
SINAMICS topology (package execution)
Dialog view during the package execution (for commissioning engineers / operators)
The three possible dialog versions are subsequently described:
● Comparison topology
● User-specified topology
● Manual DO variable assignment
Comparison topology
This dialog version is used if "Initial state", "Offline archive" or "Automatic configuration" is used
for the device configuration for drives and a Comparison topology was selected under the
SINAMICS topology.
The following diagram is an example for the dialog page using a comparison topology after
automatic device configuration.
Figure 4-34
Performing axis-drive assignment
Setting the check mark activates automatic axis-drive assignment.
SINUMERIK Integrate Create MyConfig - Diff, Expert, Topo
Operating Manual, 11/2016, A5E36537479B-AD
SINAMICS topology - commissioning engineer/operator view - example for comparison
topology
Create MyConfig - Expert
4.4 Project folder
175