Section 21 Hitachi User Debug Interface (H-Udi); Overview; Features; Block Diagram - Hitachi SH7750 Hardware Manual

Sh7750 series superh risc engine

Hide thumbs Also See for SH7750:

Table of Contents

Section 21 Hitachi User Debug Interface (H-UDI)

The Hitachi user debug interface (H-UDI) is a serial input/output interface conforming to JTAG,

IEEE 1149.1, and IEEE Standard Test Access Port and Boundary-Scan Architecture. The

SH7750R's H-UDI supports boundary-scan, but is used for emulator connection as well. The

functions of this interface should not be used when using an emulator. Refer to the emulator

manual for the method of connecting the emulator. The H-UDI uses six pins (TCK, TMS, TDI,

TDO, TRST, and ASEBRK/BRKACK). The pin functions and serial transfer protocol conform to

the JTAG specifications.

Figure 21.1 shows a block diagram of the H-UDI. The TAP (test access port) controller and

control registers are reset independently of the chip reset pin by driving the TRST pin low or

setting TMS to 1 and applying TCK for at least five clock cycles. The other circuits are reset and

initialized in an ordinary reset. The H-UDI circuit has four internal registers: SDBPR, SDIR,

SDDRH, and SDDRL (these last two together designated SDDR). The SDBPR register supports

the JTAG bypass mode, SDIR is the command register, and SDDR is the data register. SDIR can

be accessed directly from the TDI and TDO pins.

Rev. 6.0, 07/02, page 799 of 986

Table of Contents

Sh7750r Sh7750s