Toshiba GR200 Series Instruction Manual page 527

Hide thumbs Also See for GR200 Series:

Receiving "Select command Off" by PLC function

Figure 4.1-9 outlines the reception of the select command 'Off ' by the PLC function.

Wait for a command

Selection logics

Select command On from remote-end

Select command Off from remote-end

Select command On from front panel

Select command Off from front panel

Select command On by the PLC

Select command Off by PLC

PLC logic programmed

Input signal from the PLC function

Figure 4.1-12 shows the select logic when a "Select command Off (PLC-OFF-Control)" signal

is generated by the PLC function. There are two input points for the reception of this signal,

like in the signal "Select command On (PLC-On-Control)" where four are available. That is, if

DEV01_OP_INTERLOCK). Alternatively, if the interlock-check is not required, use the

connection point (PLC#2; e.g., DEV01_OP_COMMAND). PLC#1 and PLC#2 is shown Table

Selection logic

Figure 4.1-11 Outline of select command 'Off'

Signal output

6F2S1915 (0.46)

Wait for a next command

Cancel logic

Cancel command

Cancel logic

Operate logic

Operate command

Operate logic

(PLC#1:e.g.,

GRZ200 (Soft 031 & 032)