Samsung DCS Programming Manual page 131
Hide thumbs
Also See for DCS:
- Programming manual (410 pages) ,
- Technical manual (287 pages) ,
- Installation manual (75 pages)
Table of Contents
Advertisement
SAMSUNG DCS
TECHNICAL MANUAL
MMC: 508
COST
DESCRIPTION:
Allows change the system administrator to program attributes of Call Cost to be generated by the
system either on LCD during on a call or SMDR record. Attributes are listed below.
0. UNIT COST PER MP
1. CALL COST RATE
WARNING !!!
Beware of changing this value when there is a being progressed CO line
under MP detection may result in inaccurate call cost.
PROGRAM KEYS
UP & DOWN
KEYPAD
SOFT KEYS
SPK
ACTION
1.
Press TRSF 508
Display shows the first item
2.
Dial 0 or 1
OR
Press UP or DOWN key for selection and press RIGHT
soft key to move cursor
3.
Enter new value (e.g., 111 for 111 percent)
System returns to step 2
4.
Press TRSF to store and exit
OR
Press SPK to store and advance to next MMC
DEFAULT DATA:
When the system is installed to receive MP on a CO outgoing call. It
is used for generating total call cost by multiplying with the number
of pulses. The MMC will allow to enter 5000 as a maximum value.
This will generate additional call cost calculated by multiplying this
rate to the original call cost. It ranges fro 100 through 255.
Used to scroll through options
Used to enter selections
Move cursor left and right
Used to store data and advance to next MMC
UNIT COST PER MP
CALL COST RATE
PROGRAMMING
December 1996
CALL
DISPLAY
UNIT COST PER MP
0200PENCE
UNIT COST PER MP
0200PENCE
CALL COST RATE
100% 111
CALL COST RATE
111%
200 PENCE (UK)
100 PRECENT
Advertisement
Table of Contents
