Siemens Sinumerik 840D Operating Turning page 630

Hide thumbs Also See for Sinumerik 840D:

Complex programming example

In order to insert a tool into the parameter mask,

press the VSK 1 "Select tool", mark the appropriate

tool (FINISHING_TOOL_A80) with the orange selec-

tion cursor and press the VSK 1 "To program".

Accept your selection by pressing the VSK 8

The following program block "Stock removal" will be

inserted into the work plan:

The program chain is closed

Program the end of the program and simulate the

machining of the program.

Place the orange selection cursor on the program

block "End of program" and switch to the parameter

mask by pressing the blue "cursor to-the-right" key

on the keyboard.

The settings window for the program end opens,

where you can define to repeat the workpiece.

Accept the default value by pressing the VSK 8

The following program block "End of program" is

inserted into the work plan:

Press the HSK 1.7 "Simulation" to start the simula-

tion of the program run.

The control calculates the simulation and starts the

simulation in an animation window showing the ma-

chining in a side view on the blank.

840D/828D SINUMERIK Operate

Sinumerik 828d