Siemens Sinumerik 840D Operating Turning page 497

Hide thumbs Also See for Sinumerik 840D:

Simple measurement example

Press the VSK 1.1 "To Program".

The program line N120 T="3D_PROBE_BLUM"

is inserted into the program.

Conversely you can also programme this line manu-

Enter the following G-Code commands into the pro-

N140 G0 X0 Y0 Z5

N150 G0 Z-10

Now programme the measuring cycle.

For this press the key "Extension" on the operator

panel to swap to the horizontal softkey-strip 2.

The horizontal softkey-strip 2 is opened.

Press the HSK 2.6 "Measurem. milling".

The operating range "Measurement milling" with ex-

tended measuring functions is opened.

Press the VSK 4 "Workpiece measure".

The vertical softkey-strip with functions for the meas-

uring of work pieces is opened.

Press the VSK 2 "Hole Shaft".

The vertical softkey-strip with functions for the meas-

uring of holes or shafts is opened.

The key "Hole". is pre-set and is therefore shown in

The input window for den Cycle 977 "Meas. Hole/

CYCLE977" is opened.

Enter the following values into the parameter mask:

Si840D/828D SINUMERIK Operate

Sinumerik 828d