Siemens Sinumerik 840D Operating Turning page 627

Hide thumbs Also See for Sinumerik 840D:

Complex programming example

By entering the values for "Z" an "X" , the values for

"α1" and "α2" are calculated automatically.

Confirm your inputs by pressing the VSK 8 "Accept".

Extend the contour by adding a straight line in Z di-

Press the VSK 1.2 "Straight line Z".

The parameter window for the contour element

"Straight line Z" opens.

Fill out the parameter mask as follows:

By entering the value for "Z" , the values for "α1" and

"α2" are calculated automatically.

Confirm your inputs by pressing the VSK 8 "Accept".

Now, examine the finished contour outline.

For this, switch with the orange selection cursor to

the yellow contour step bar on the left side of the

screen, by pressing blue "cursor-to-the-left"-key on

the keyboard.

Place the orange selection cursor on the "END"-

Symbol in the yellow contour step bar, by using the

blue "cursor-down"-key on the keyboard.

The following screen with a sketch of the contour outline will be displayed:

840D/828D SINUMERIK Operate

Sinumerik 828d