Siemens Sinumerik 840D Operating Turning page 298

Hide thumbs Also See for Sinumerik 840D:

Magazine management

Tools are displayed with their magazine-related data in the magazine list.

Here, you can take specific actions relating to the magazines and the

magazine locations.

Individual magazine locations can be location-coded or disabled for exist-

Selecting the function "Magazine"

By pressing the HSK 4 "Magazine" the following

magazine list will be displayed on the screen.

In the magazine list, all magazine locations are shown.

It is indicated whether a magazine location is available, disabled or

occupied by a tool.

If a magazine location is defect, this location can be disabled.

If an oversized tool is inserted, which uses more than a half of the

neighbouring magazine locations, then the neighbouring magazine loca-

tions will be disabled.

Vertical softkey bar

Display area

By pressing the VSK 5 "Relocate" a tool can be

transferred from one magazine location to another

or, with pressing the VSK 4 "Spindle", it can be

transferred to the spindle. The selected target loca-

tion must be confirmed with the VSK 8 "ok" or can

aborted with VSK 7 "Cancel".

By pressing the VSK 6 "Position magazine" you can

position magazine locations directly on the loading

point. (See section 5.6)

By pressing the VSK 1.8 "Extend" on the operator

panel the extended vertical softkey bar 2 opens

with the functions "Sort", "Filter" and "Details"

(see sections 3.12 and 3.13).

840D/828D SINUMERIK Operate

Sinumerik 828d