Table of Contents
Advertisement
Praesideo 3.5 | Installation and User Instructions | 6 | Installation Accessories
29.4.4 Crimping bush
Proceed as follows:
6 Slide the crimping bush over the cable and position
it at the end of the outer sheath.
Note
In the next step, the circular shape of the cable
cross-section at the end of the outer sheath is
transformed into a hexagonal shape using the
crimping tool (tool 3) and the crimping bush.
Before crimping the bush, ensure that both
plastic optical fibers will be positioned parallel
to a flat side of the hexagonal cross-section
(see figure 29.8)
R
B
B
R
figure 29.8: Cross-section transformation
Bosch Security Systems | 2011-02
B
R
A
R
= Red
B
= Brown
A
7 Crimp the bush on the outer sheath using the
crimping tool (tool 3, see figure 29.9). The crimping
bush will prevent the cable from rotating in the
connector.
figure 29.9: Crimping the bush
29.4.5 Stripping copper wires
Proceed as follows:
8 Cut the copper wires at the required length using the
cable cutter (tool 2) and the stripping tool (tool 5). To
this end, position the crimping bush in position I and
B
cut the copper wires at position II (see figure 29.10).
figure 29. 1 0: Cutting a copper wire
en | 283
I
II
Advertisement
Table of Contents
