Table of Contents
Advertisement
2011-02 | Installation and User Instructions | 5 | Call Stations
19.3
Installation
The call station keypad kit contains four holes for
installation purposes (see figure 19.8).
80
90
figure 19.8: Installation
The kit is delivered together with Tyco AMP pin
headers and Tyco AMP 1-141708-1 shrink-contacts (see
figure 19.9) to facilitate the connection of wires to the
PCB. These pin headers are suitable for wires with a
cross-section from 0.2 to 0.56 mm2. It is possible to
solder the wires to the pin headers.
Note
If the call station keypad kit is installed in a
vibrating surrounding (e.g. a ship), glue the pin
header to the PCB.
figure 19.9: Tyco AMP 1-141708-1 shrink-contact
Bosch Security Systems | 2011-02
To connect the wires to the shrink-contacts, use one of
the following pliers (see also the following figures):
•
Tyco AMP 169111-1 pliers (see figure 19.10)
•
Tyco AMP Modu 4 169481-1 pliers (see figure 19.11)
figure 19. 1 0: Tyco AMP 169111-1 pliers
figure 19. 1 1: Tyco AMP Modu 4 169481-1 pliers
en | 231
169111-1
MODU 4
16 9 4 81 - 1
Advertisement
Table of Contents
