Paper Jam In Finisher Section; [Ea10] Paper Transport Delay Jam; [Ea10] Transport Delay Jam (Paper Not Inserted) - Toshiba e-STUDIO206L Service Manual
Multifunctional digital systems
Hide thumbs
Also See for e-STUDIO206L:
- Troubleshooting manual (132 pages) ,
- Quick start manual (90 pages) ,
- User manual (42 pages)
Table of Contents
Advertisement
[ 5 ] Paper jam in finisher section
[EA10] Paper transport delay jam
Classification
Paper jam in finisher section
MJ-1101/1107
Check item
Removing paper
Entrance sensor
Gate solenoid
Entrance motor
Harness check
Parts to be replaced
Entrance sensor
Finisher controller PC board
[EA10] Transport delay jam (paper not inserted)
MJ-1106/1108
Classification
Paper jam in finisher section
Check item
Removing paper
Feeding sensor (S22)
Transport path switching
solenoid (SOL5)
Entrance motor (M1)
Interface PC board (I/F)
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
ERROR CODE AND TROUBLESHOOTING
Error content
Paper transport delay jam
Measures
Check if there is any paper in the finisher or on the transport path of
the equipment and remove it if there is.
Is there a disconnection of the connector, incorrect installation or
breakage of the entrance sensor (S1)?
•
Is the gap between the flapper and entrance roller shaft other
than 0.600.20mm when the gate solenoid (SOL2) is pulled?
•
Is the harness between the gate solenoid (SOL2) and the
finisher control PC board (CN22) disconnected or open
circuited?
Is the harness between the entrance motor (M1) and the finisher
control PC board (CN7) disconnected or open circuited?
Is the harness between the gate solenoid (SOL2) and the finisher
control PC board (CN22) disconnected or open circuited?
Remark
Error content
Transport delay jam (paper not inserted)
Measures
Check if there is any paper in the finisher or on the transport path of
the equipment and remove it if there is.
Check if there is a disconnection of the connector, incorrect
installation or breakage of the feeding sensor (S22). If there is,
reinstall the sensor correctly or replace it.
Check that the gap between the transfer guide surface and the
upper surface of the flapper tip is in the acceptable range according
to the status of the transport path switching solenoid (SOL5)
(solenoid OFF: 1.5 to 2.1 mm, solenoid ON: 2.3 to 2.9 mm). If it is
not, adjust it.
Check the harness between the entrance motor (M1) and the
finisher controller board (CN26). If there is any abnormality, correct
it.
Check the harness between the transport path switching solenoid
(SOL5) and the interface PC board (CN6), If there is any
abnormality, correct it.
•
Board check
•
Connector check (CN5, CN6, CN7)
•
Harness check
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
8 - 92
- Quick Links:
- Service Manual
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
