Adjustment Of Horizontal Position - Toshiba e-STUDIO206L Service Manual

Multifunctional digital systems

Hide thumbs Also See for e-STUDIO206L:

Table of Contents

Adjustment of horizontal position

Check if the image adjustment for the equipment is performed properly before this adjustment of

the RADF. Also, the RADF position and height shall be adjusted properly.

[A] Checking

Check the image using the chart (original) with a center line in the following procedure.

Place the chart provided as an original with its face up on the original tray of the RADF.

Press the [START] button.

Fold the copy in half and check if the center line is misaligned.

[B] Adjustment

Turn the power ON while pressing [0] and [5] simultaneously.

Key in [3043] and then press the [START] button.

If the center line of the copy image is shifted to the front side of the equipment, enter a value

larger than the current one.

Changing one value shifts the copy image by 0.042 mm.

If the center line of the copy image is shifted to the rear side of the equipment, enter a value

smaller than the current one.

Changing one value shifts the copy image by 0.042 mm.

Press the [OK] button.

e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507

SETTING / ADJUSTMENT

Show Quick Links

Table of Contents