Hdd Securely Erasing (Erase Hdd Securely); Sram Securely Erasing (Erase Sram Securely); Sram Service Tech Password Formatting (Clear Service Tech Password) - Toshiba e-STUDIO206L Service Manual

Multifunctional digital systems

Hide thumbs Also See for e-STUDIO206L:

Table of Contents

4. License FROM to SRAM

Back up the license from FROM to SRAM.

5. ADIKey SRAM to FROM

Restore the ADIKey from SRAM to FROM.

6. ADIKey FROM to SRAM

Back up the ADIKey from FROM to SRAM.

HDD securely erasing (Erase HDD Securely)

This function is used before discarding the HDD.

It overwrites all the used areas on the HDD with the selected data, and makes it unusable.

After selecting this function, specify the level below to be overwritten.

This is the standard overwriting method.

This overwriting method is more secure than LOW. The erasing time is between LOW and

This is the most secure overwriting method. It takes the longest time to erase data.

This is the simple overwriting method. It takes the shortest time to erase data.

Key in the level number to display ">" next to it.

(At this time, if "0" is entered, the screen returns to the initial one of the Assist Mode.)

Press the [START] button to display the reconfirmation screen, and then press the [START]

button again to start overwriting.

When this operation has been done, do not perform SRAM data formatting (Clear SRAM) before

the normal start-up.

This function is used before discarding the SRAM board (for the SYS board).

It overwrites all the used areas on the SRAM board with the selected data, and makes it

Immediately after selecting this function, the processing starts and is completed.

This function is needed after the HDD is replaced.

When the HDD is replaced, the service tech password stored in the new one is set as a blank.

Therefore, its password is copied to the SRAM board so that both passwords become the same

with this function.

e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507

SELF-DIAGNOSIS MODES

Show Quick Links

Table of Contents