Toshiba e-STUDIO206L Service Manual page 505

Multifunctional digital systems

Hide thumbs Also See for e-STUDIO206L:

Table of Contents

[A] Registration of the number of punch holes

Turn OFF the power of the equipment.

Take off the rear cover of the finisher.

Set the bits 1, 2 and 4 of the DIP switch [2] on the hole punch control PC board (HP) [1] to ON.

Then turn ON the power of the equipment while pressing the push button switch [3] on the hole

punch control PC board (HP) [1] and the digital keys [0] and [8] on the control panel of the

Select the number of punch holes by setting the bits from 1 to 4 of the DIP switch [2].

See the table below for registering the number of punch holes.

Number of punch holes

2/3 holes (N)

The number of punch holes is registered in the hole punch control PC board (HP) [1] by pressing

the push button switch [3].

LEDs [4] on the hole punch control PC board (HP) [1] start blinking as the registration is started.

When the registration is completed, the LEDs [4] are lit.

Turn OFF all bits of the DIP switch [2].

Install the rear cover of the finisher.

e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507

SETTING / ADJUSTMENT

Show Quick Links

Table of Contents

Troubleshooting