Table of Contents
Advertisement
<THMEN>
• Enter 1(=On) to enable the Thermal OL and press the ENTER key. If disabling the Thermal
OL, enter 0(=Off) and press the ENTER key.
<THMAEN>
• Enter 1(=On) to enable the Thermal Alarm and press the ENTER key. If disabling the
Thermal Alarm, enter 0(=Off) and press the ENTER key.
<NPS1EN>, <NPS2EN>
• Enter 1(=On) to enable the NPS1EN and NPS2EN and press the ENTER key. If disabling the
NPS1EN, enter 0(=Off) and press the ENTER key.
<BCDEN>
• Enter 1(=On) to enable the Broken Conductor and press the ENTER key. If disabling the
Broken Conductor, enter 0(=Off) and press the ENTER key.
<NPS1-2F, NPS2-2F, BCD-2F>
• Enter 1(=Block) to block the NPS1, NPS2 and BCD against the inrush current, and press the
ENTER key.
<BTC>
• Enter 1(=On) to set the Back-trip control and press the
Back-trip control, enter 0(=Off) and press the
<RTC>
To set the Re-trip control, do the following.
• Enter 0(=Off) or 1(=Direct) or 2(=OC controlled) and press the
<CLSG>
To set the Cold Load settings group, do the following.
• Enter 0(=Off) or 1(=1) or 2(=2) or 3(=3) or 4(=4) and press the
<CLDOEN>
• Enter 1(=On) to enable the Cold Load drop-off and press the
Cold Load drop-off, enter 0(=Off) and press the
• After setting, press the
C h a n g e
E N D = Y
• Press the
(=Y) key to change settings and return to the "Scheme sw" screen.
ENTER
ENTER
key to display the following confirmation screen.
END
s
e
t
t
C A N C E L = N
125
key. If not setting the
ENTER
key.
ENTER
ENTER
ENTER
key.
ENTER
i
n g s
?
6 F 2 T 0 1 7 2
key.
key.
key. If disabling the
- Quick Links:
- Inverse Time Overcurrent Protection
Hide quick links:
Advertisement
Table of Contents
