34
en | Installing Roof Parapet and Pipe Mounts
2.8
Assemble the Pendant in Packing Box
The AutoDome Pendant can be assembled before attaching it to the roof or pipe mount. The
Pendant includes a Housing, Camera Module, and Bubble.
1.
Open the box containing the Pendant Housing from the top, and remove the two card-
board inserts from the top of the box.
2.
Remove the plastic bag from the Pendant Housing, and then place it back into its box.
NOTICE! The Pendant Housing box is designed to hold the housing in-place during the
i
assembly of the Pendant.
3.
Remove the Camera Module from its packing box, and remove the protective plastic bag.
4.
Align the yellow locking tab on the Camera Module base to the (yellow) label on the CPU
board, and gently seat the camera onto its connector.
Fig. 2.15 Align Lock Tab and Install Camera Module
5.
Rotate the base of the Camera Module clockwise (approximately 60 degrees) until the
yellow tab locks in place.
NOTICE! The Camera Module must be able to rotate freely when installed in the housing.
i
F01U010921 | 1.0 | 2006.10
Installation Manual
AutoDome Modular Camera System
Bosch Security Systems, Inc.