AutoDome Modular Camera System
2.7
Wire Pipe Interface Board
This section provides instructions for connecting wires and cables to the Pipe Interface Board,
as illustrated below. See Chapter 4: Cable and Wire Standards for cable and wiring recommen-
dations and specifications.
#2
DATA
IN/OUT
Fig. 2.12 Pipe Interface Board Connections
WARNING! 24 VAC Class II power supply only.
!
Bosch Security Systems, Inc.
VIDEO
COAX
IN
BNC
- BIPHASE 1
+ BIPHASE 2
EARTH GROUND 3
- RxD 4
+ TxD 5
SIGNAL GND 6
RJ45
Ethernet
or UTP Video
TO AUTODOME
Installation Manual
Installing Roof Parapet and Pipe Mounts | en
6 GND
5 ALARM #7
CABLE TIE SLOT
4 ALARM #6
3 ALARM #5
2 ALARM #4
6-PIN CONNECTOR
1 ALARM #3
ALARMS IN (3 - 7)
4 GND
4-PIN CONNECTOR
ALARMS OUT (1 - 3)
7 GND
#1
6 ALARM #2
ALARMS IN
5 ALARM #1
(EoLR Supervised)
4 EARTH GROUND
(1 -2)
3 N.C.
RELAY OUTPUT
2 COM
1 N.O.
3 DOME 24VAC
#3
2 EARTH GROUND
DOME POWER
1 DOME 24VAC
2 HEATER 24VAC
HEATER POWER
1 HEATER 24VAC
WIRE GAUGE CHART
#1: AWG 26-16
#2: AWG 26-16
#3: AWG 18-14
F01U010921 | 1.0 | 2006.10
31