Bosch AutoDome VG4-A-9230 Series Installation Manual page 33

Modular camera system
Table of Contents

Advertisement

AutoDome Modular Camera System
2.4.1
Wiring the Power Supply Box
1.
Route the high voltage 115/230 VAC lines through the conduit fitting on the left side of
the box.
NOTICE! The Power Supply Box with transformer comes with a barrier that separates the high
i
voltage side on the left from the low voltage 24 VAC side on the right.
2.
Cut and trim the high voltage 115/230 VAC power and ground wires with sufficient slack
to reach their connector terminal in the box, but not so long as to be pinched by or to
obstruct closing the Cover Door. See Figure 2.6 on page 25 for connector location.
3.
Attach the supplied 3-pin Power Plug to the incoming high voltage power wires in the
box. See connector P101 in Table 2.1 on page 25.
4.
Route low power 24 V wires from the right side of the Power Supply Box out to the where
the AutoDome will be mounted, and attach the supplied 5-pin 24 VAC Dome plug to the
wire ends inside the box. See connector P107 in Table 2.1 on page 25.
5.
If you are using UTP for video or Ethernet, route the UTP cable out to where the
AutoDome will be mounted. See Chapter 4: Cable and Wire Standards for fiber optic spec-
ifications.
NOTICE! All video, control, and alarm wires either pass through the Power Supply Box or by-
i
pass through it and connect directly to the Pipe Interface Board.
2.4.2
Wiring the Fiber Optic Model
1.
If installing a Fiber Optic model, bring the fiber optic cable into the right side of the
power supply box.
2.
Route a video coax cable from the Power Supply Box to the Pipe Interface Board. Then
attach a BNC connector to the cable end inside the Power Supply Box. See Chapter 4:
Cable and Wire Standards for fiber optic specifications.
NOTICE! You will need a barrel connector (not supplied) to connect the BNC connector from
i
the Pipe Interface Board coax cable to the Fiber Optic Module BNC connector.
Bosch Security Systems, Inc.
Installing Roof Parapet and Pipe Mounts | en
Installation Manual
23
F01U010921 | 1.0 | 2006.10

Advertisement

Table of Contents
loading

This manual is also suitable for:

Autodome 300 seriesAutodome vg4 seriesVg4-323-ets

Table of Contents