16
en | Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts
Removing the Pendant Bubble
To service the AutoDome Pendant, use the following procedure to remove the Bubble:
1.
Using both hands, apply a counterclockwise (looking up at the dome) rotational force on
the Pendant Bubble Assembly to set the bubble latch.
2.
Insert a small (2 mm) straight blade screw driver into the bubble release opening in the
bubble trim-ring to release the lock, and then remove the screwdriver. See the figure
below.
3.
Rotate the Bubble Assembly counterclockwise approximately 20 degrees until the bubble
assembly releases from the Pendant Housing.
Fig. 1.13 Pendant Bubble Release Opening
F01U010921 | 1.0 | 2006.10
Installation Manual
AutoDome Modular Camera System
Bosch Security Systems, Inc.