Table of Contents
Advertisement
6-22
Troubleshooting: TDU Troubleshooting Tables and Status LEDs
LED Status
LED is OFF
Check the 24 VDC control circuit supply is connected correctly to the X2
connector and is powered on.
Flashing Red
Powerbase fault or error(s) present. The number of flashes indicates
which error has occurred. For example, to display error 3 (overcurrent
trip), the LED flashes 3 times at 0.1 second intervals, followed by a 0.5
second pause. The sequence is repeated continuously.
If multiple errors occur at the same time, the lowest numbered error code
will be flashed. For example, a MicroFlex which has tripped on both
feedback error (code 5) and over-current error (code 3) will flash error
code 3. If the drive is already displaying an error code when a new error
with a lower code occurs, the drive will start flashing the new code. Note
that undervoltage trip does not appear in the table because it is already
indicated by the green/red flashing state. If an undervoltage trip occurs in
conjunction with another error, the drive will flash the code of the
additional error.
See the troubleshooting table below for the event / error code and it's
corresponding red flashing LED.
GE T2100 Treadmill
2021403-031
Description
Revision A
Advertisement
Table of Contents
Troubleshooting
