Table of Contents
Advertisement
Walking Belt Tracking Adjustment
4-6
Maintenance: Walking Belt Tracking and Tension Adjustment
1. Use the controlling equipment to set the walking belt speed to 7 – 8
km/h (4 – 5 mph).
2. To correct a belt that tracks to the right, turn the right pulley
adjustment screw CLOCKWISE in 1/8-turn increments until the belt
tracks in the center. Wait 2 or 3 minutes between each 1/8-turn to
allow the belt position to stabilize.
To correct a belt that tracks to the left, turn the left pulley
adjustment screw CLOCKWISE in 1/8-turn increments until the belt
tracks in the center. Wait 2 or 3 minutes between each 1/8- turn to
allow the belt position to stabilize.
NOTE
Make adjustments to the pulley screws in small increments.
Over-adjustments and repeated tightening of the screws can
cause too much tension on the belt.
3. If either adjustment in step 2 results in an over-adjustment of the
belt tracking, loosen the pulley screw that was tightened and wait
several minutes for the GE T2100 Treadmill belt position to stabilize.
Then tighten the other pulley adjustment screw.
4. Increase the speed to 16 – 19 km/h (10 – 12 mph) and verify that the
belt continues to track in the center.
5. Check the walking belt tension again to verify that it has not been
loosened when adjusting the tracking. See
Adjustment"
on page 4-5.
GE T2100 Treadmill
2021403-031
"Walking Belt Tension
Revision A
Advertisement
Table of Contents
Troubleshooting
