Table of Contents
Advertisement
There are 3 mounting bolts.
The third bolt is underneath
the rubber coupling.
7-20
Assembly/Disassembly: Elevation Motor Replacement
7. Remove the two visible mounting bolts on the elevation motor.
Elevation Shaft
8. Remove the third mounting bolt underneath the rubber coupling.
NOTE
If the third mounting bolt is difficult to remove, you may have to
remove the wheel to provide adequate access to the third
mounting bolt.
9. Remove the elevation motor from its coupling.
10. Replace with a new motor in reverse order. Follow these guidelines.
a. Use a dab of lithium grease to hold the key in the motor shaft
keyway, line up the keyway with the coupling's key slot, and
slowly turn the elevation shaft until the two mate.
b. See
"Potentiometer Installation Procedure:"
procedures when installing the potentiometer.
11. Replace the tie wraps for the elevation motor wiring harness.
12. Calibrate the GE T2100 Treadmill. See
10."
GE T2100 Treadmill
2021403-031
Elevation Motor
(and Wormgear
Box are combined
as one unit)
Wormgear Box
on page 7-23 for
"Self-Calibration"
on page 3-
Revision A
035
Advertisement
Table of Contents
Troubleshooting
