Table of Contents
Advertisement
Revision A
Installation: Equipment Assembly
To activate the self-calibration routine, do the following:
1. Remove controlling device (CASE, MTC-1) cable or turn off the
controlling device.
2. Unlock the emergency stop switch.
3. Connect the AC power cable on the GE T2100 Treadmill to the wall
outlet.
WARNING
POWER CABLES – Route the AC Power cable away from
moving parts. An AC power cable caught in moving parts
could cause injury to the user and equipment.
4. Press and hold in the Calibration button.
Power Switch
5. Turn the power switch on the GE T2100 Treadmill to On.
6. Continue to hold the Calibration button until the GE T2100
Treadmill starts changing elevation (at least 4 seconds). This
initiates the self-calibration routine.
7. Wait for the self-calibration routine to complete. WHen the elevation
and the walking belt have completely stopped (approx. 2 minutes),
the self-calibration is finished.
GE T2100 Treadmill
2021403-031
Calibration Button
044
3-11
Advertisement
Table of Contents
Troubleshooting
