Toshiba TLCS-900/H1 Series Manual page 143
Original cmos 32-bit microcontroller
Hide thumbs
Also See for TLCS-900/H1 Series:
Advertisement
In this mode a programmable square wave is generated by inverting the timer
output each time the 8-bit up counter (UC0) matches the value in one of the timer
registers TA0REG or TA1REG.
The value set in TA0REG must be smaller than the value set in TA1REG.
Although the up counter for TMRA1 (UC1) is not used in this mode,
TA01RUN<TA1RUN> should be set to "1" so that UC1 is set for counting.
Figure 3.7.14 shows a block diagram representing this mode.
φT1
φT4
φT16
TA01MOD<TA0CLK1:0>
Selector
TA0REG-WR
TA01RUN<TA0RDE>
If the TA0REG double buffer is enabled in this mode, the value of the register buffer
will be shifted into TA0REG each time TA1REG matches UC0.
Use of the double buffer facilitates the handling of low duty waves (when duty is
varied).
Match with TA0REG
and up counter
Match with TA1REG
(Value to be compared)
Register buffer
Selector
8-bit
up counter
(UC0)
Comparator
TA0REG
Shift trigger
Register buffer
Internal data bus
Figure 3.7.14 Block Diagram of 8-Bit PPG Output Mode
(Up counter = Q
TA0REG
Figure 3.7.15 Operation of Register Buffer
92CH21-141
TA01RUN<TA0RUN>
Comparator
TA1REG
(Up counter = Q
)
1
Shift from register buffer
Q
1
Q
2
TMP92CH21
TA1OUT
TA1FFCR<TA1FFIE>
TA1FF
Inversion
INTTA0
INTTA1
)
2
Q
2
Q
3
TA0REG (Register buffer)
write
2009-06-19
Advertisement
