2-1. BRC-300/300P Main Parts
n
Tighten the screws as following torque.
PSW2.5/PSW2.6 screws:
B2/BTP2/PSW2 screws:
2-1-1. Camera Assembly
Removing
1. Remove the side rear assembly and side front assem-
bly. (Refer to steps 1 to 3 in Section 1-3-1.)
2. Remove the camera cabinet upper assembly.
(Refer to steps 2 to 5 in Section 1-3-2.)
3. Remove the camera cabinet lower.
(Refer to steps 3 to 5 in Section 1-3-3.)
4. Remove the SE plate.
(Refer to steps 2 to 4 in Section 2-2-9.)
5. Remove the screw, and remove the plate T4, holder
T3, two wave washers and holder T2 from the shaft R
of the camera assembly.
6. Pull out the pin from the shaft R, and remove the drive
gear T.
Camera
assembly
Pin
Shaft R
BRC-300/300P
BRU-300/300P
Replacement of Main Parts
26.0 x 10
_2
N.m
18.0 x 10
_2
N.m
Drive gear T
Holder T2
Wave washer
Holder T3
PSW
2.6 x 6
Plate T4
Section 2
7. Loosen the two screws, and remove the holder T1.
Screws
8. Remove the harness cap from the camera assembly.
9. Disconnect the flexible flat cable shown in the figure
from the connector on the camera assembly.
Camera assembly
Connector
Holder T1
Harness
cap
2-1