Sony DVS-9000 System User Manual page 73
Hide thumbs
Also See for DVS-9000 System:
- User manual (1228 pages) ,
- Installation manual (42 pages) ,
- Operation manual (24 pages)
Table of Contents
Advertisement
When the [TIMELINE] button is off:
Displays the Cueup & Play (rewind
action) start and stop points.
b Device selection buttons
These buttons are used for selecting
assigned external devices or frame memory
clips. Each button can only be assigned to a
single device. Carry out the assignment in
the Setup menu (see "Overall Control
Panel Settings (Config Menu)" in Chapter
19 (Volume 3)). To select an assigned
device, press the corresponding button,
which lights green. To select more than one
device simultaneously, hold down the
button for the first selection, while pressing
the buttons for the other selections in turn.
The second and subsequent selected
buttons light amber. If you press another
button without holding down the first
selected button, the second button will be
the reference device and light green.
DEV: Assign external devices DEV1 to
DEV12.
FM CLIP: Assign frame memory clips
FM1 to FM8.
Device selection buttons can be set as
SBOX buttons or DELAY button in the
Setup menu.
c SBOX (shotbox) buttons
Assign a shotbox saved in registers 1 to 99.
When you press a button, the assigned
shotbox is selected, and executed. Carry out
the assignment in the Setup menu (see
"Overall Control Panel Settings (Config
Menu)" in Chapter 19 (Volume 3)).
SBOX buttons can be set as device
selection buttons or DELAY button in the
Setup menu.
d DELAY button
When pressed, this button lights green, the
numeric keypad control block display
changes to DELAY__ : , and you can set
the start delay time for the selected device.
The setting range is from 00:00 to 59:29
(depends on the video format). This button
goes off when another timecode setting
button ([START TC], [STOP TC], [SET
START TC], [SET STOP TC], or [SET
DUR]) is pressed.
The DELAY button can be set as a device
selection button or an SBOX button in the
Setup menu. Carry out the assignment in
the Setup menu (see "Overall Control
Panel Settings (Config Menu)" in Chapter
19 (Volume 3)).
e Editing buttons
These carry out Cueup & Play (rewind
action) operations on material, and timeline
settings. These operations are only valid
while a device is selected with the device
selection buttons.
START TC: When pressed, this button
flashes amber, and sounds a beep,
setting the timecode at that time as the
device start point (on the timeline when
the [TIMELINE] button is On, and
Cueup & Play start point when Off). If
you press once more, the timecode at
that time is overwritten as a new start
point.
STOP TC: When pressed, this button
flashes amber, and sounds a beep,
setting the timecode at that time as the
device stop point (on the timeline when
the [TIMELINE] button is On, and
Cueup & Play stop point when Off). If
you press once more, the timecode at
that time is overwritten as a new stop
point.
SET START TC, SET STOP TC, SET
DUR: When pressed, these buttons
light green, "START TC", "STOP TC"
or "DUR" appears in the numeric
keypad control block display, and you
can enter a timecode from the numeric
keypad. If you enter a numeric value
and press the [ENTER] button, the
button goes off, whereas if you press
Names and Functions of Parts of the Control Panel
73
Advertisement
Table of Contents
