Separate Sides Settings - Sony DVS-9000 System User Manual

Hide thumbs Also See for DVS-9000 System:

Table of Contents

Selecting the signal to insert in the background

When using the BKDS-9470 or MVE-9000, you can select the signal to insert

in the background.

With [Bkgd] set on, use the following procedure.

In the <Bkgd Fill> group, select one of the following.

Flat Color: single color

Mix Color: mix color signal set in the Color Mix menu (see page 475)

Ext Video: an external video signal input to the Ext IN connector

• "Mix Color"or "Ext Video" can only be applied to one of the

background, flex shadow (see page 464), trail (see page 527), and wind

(see page 535) effects.

If you select "Mix Color" or "Ext Video" in one of these settings, a

selection of "Mix Color" or "Ext Video" in any of the other effects is

disabled, and "Flat Color" is selected in its place.

• When executing combining four channels of DME images, "Mix Color"

and "Ext Video" cannot be selected.

Only if Flat Color is selected in step 1, adjust the following parameters.

Separate Sides Settings

Applies separate video signals and key signals to the front and back of the

Applying the Separate Sides effect

In the DME menu, select VF6 'Input/Output' and HF2 'Video/Key.'

The Video/Key menu appears.

Press [Separate Side], turning it on.

The Separate Sides effect is enabled. If the video and key signals currently

being output to the monitor are the front side, you can select the front

Setting values

0.00 to 100.00

359.99 to 0.00

DME Special Effect Operations

Dvs-9000sf system