Short Circuit Isolators (Addressable) - Panasonic EBL128 Planning Instructions
Fire alarm system
Hide thumbs
Also See for EBL128:
- Planning instructions (179 pages) ,
- Operating instructions manual (152 pages) ,
- User manual (42 pages)
Table of Contents
Advertisement
Panasonic Electric Works Nordic AB
MEW01090
Rev: 3
6.1.4
and two priority levels are available. For each level an output
control expression and a sound type is programmed (via
Win128). For more technical data, see the Product Leaflet.
The technical address is set with an Address setting tool (AST)
3314. The unit has an address label on which the programmed
technical address is to be written. (The detector has its own
technical address set via the Address setting tool 3314.)
The Address setting tool 3314 is also used for mode setting:
NORMAL mode: Used for 3378 in EBL128.
2330 mode: Not used in EBL128.
2312 mode: Not used in EBL128.
NOTE! See also chapter "Limitations", page 144.
3379 Addressable sounder base.
(3312) mounted together with a sounder. 3379 is mounted in
the ceiling. An analog detector can be plugged in the base,
which has screw terminals for the COM loop and an ext. LED
(2218).
Prepared for mechanical lock of the detector - if
required.
Recess for label holder (3391).
supplied via the COM loop, i.e. the number of sounder bases is
depending on the type and number of other units connected to
47
the COM loop
. Three sound types (tones) and two priority
levels are available. For each level an output control expression
and a sound type is programmed (via Win128). For more
technical data, see the Product Leaflet.
The COM loop address is set with the Address setting tool
(3314). The unit has an address label on which the programmed
COM loop address can be written. (The detector has its own
COM loop address set via the Address setting tool 3314.)
The Address setting tool 3314 is also used for mode setting:
NORMAL mode: Used for 3379 in system EBL128.
2330 mode: Not used in system EBL128.
2312 mode: Not used in system EBL128.
NOTE! See also chapter "Limitations", page 144.
Short circuit isolators (addressable)
Each COM loop short circuit isolator is to be programmed (via
Win128) regarding:
Technical address
Name (Normally not changed)
Sequence Number (Serial Number in the COM loop's A-
direction.)
Connections, see drawing 128-21. (See especially about the L wire!)
4313 Analog base with isolator. An analog base with a built-in short
circuit isolator with the same function as the Addressable short
circuit isolator 4370, see below. See also page 32.
48
This unit has replaced the Sounder base 3378.
EBL128 Planning Instructions V1.1.x
48
3379 consists of an analog base
41
3379 is power
Advertisement
Table of Contents
