Opening And Closing The Hp Server; Introduction; Mounting The Front Bezel; Removing And Replacing The Front Bezel - HP Integrity rx4610 User Manual
Hp server rx4610 user guide
Hide thumbs
Also See for Integrity rx4610:
- User manual (201 pages) ,
- Service manual (147 pages) ,
- Installation manual (16 pages)
Table of Contents
Advertisement
2
Opening and Closing the HP
Server
Introduction
This chapter describes how to remove and replace the front bezel and the HP
Server's main cover.
Mounting the Front Bezel
The front handles, if not already installed on the HP Server, should be attached to
the front of the HP Server before mounting the bezel.
1. Place the handles into the slots on the front of the HP Server on each edge,
as shown in the figure below.
2. Insert the screws through the bracket into the top hole of each group of
three holes on the front sides of the HP Server. Repeat this procedure for
both handles.
3. Hold the bezel in front of the HP Server.
4. Press the bezel firmly into place.
You should hear several clicks as the bezel snaps into place on the bracket.
Removing and Replacing the Front Bezel
The bezel is packed in the top tray.
1. To remove the bezel, pull it straightforward off the chassis.
This exposes the power supplies, mass storage devices, and fans.
2. To replace the bezel, press it back onto the chassis, allowing it to snap into
place. See Figure 2-1.
13
Advertisement
Table of Contents
Troubleshooting
