Removing A Hard Disk Drive - HP Integrity rx4610 User Manual
Hp server rx4610 user guide
Hide thumbs
Also See for Integrity rx4610:
- User manual (201 pages) ,
- Service manual (147 pages) ,
- Installation manual (16 pages)
Table of Contents
Advertisement
Chapter 4
Table 4-1. SCSI Drive Status LED Descriptions
SCSI drive present
SCSI drive
with power on
Green LED
Green LED
Left
On
On
Off
On
Off
Removing a Hard Disk Drive
To remove a hard disk drive from the disk bay, complete the following procedure:
1. Look at the amber LEDs above the hard disk bays to determine which
drive is bad. See Table 4-1 for information on how to interpret the LEDs.
2. Remove the plastic bezel on the front of the server.
3. Depress the drive carrier latch of the bad drive, and use the handle to pull
the assembly toward you to disengage the drive from the backplane
connector.
30
SCSI drive
active
faulty*
Amber LED
Middle
Right
Off
Off
Blinking
Off
Off
On
Off
Slow Blinking
Off
Off
Installing Mass Storage Devices
Description and Action
(If Required)
Drive is present with
power.
Drive is present with
power and is being
accessed.
Steady amber fault light
indicates drive has a
problem.
Drive SHOULD NOT be
replaced at this time. A
slowly blinking amber
fault light indicates that a
drive that has just been
replaced is in recovery
mode (drive array being
rebuilt). Power to drive is
on.
There is no drive installed
in the bay.
Advertisement
Table of Contents
Troubleshooting
