Installing The Pci Hot Plug Led Board - HP Integrity rx4610 User Manual
Hp server rx4610 user guide
Hide thumbs
Also See for Integrity rx4610:
- User manual (201 pages) ,
- Service manual (147 pages) ,
- Installation manual (16 pages)
Table of Contents
Advertisement
Chapter 8
Installing the PCI Hot Plug LED Board
To install the PCI Hot Plug LED Board, complete the following steps:
1. Observe all safety and ESD precautions for handling electronic
components.
2. Carefully place the PCI Hot Plug LED Board on the inside back of the
server chassis in such a way as to line up the four, black pin receptacles
with their respective holes.
NOTE
It is suggested that you place a piece of paper on the inside of
the chassis just below the board as you insert the black
retaining pins as a safeguard should they slip from your
fingers.
3. Press the pins through the holes in the board and through their receptacles
in the chassis.
4. Connect the cable to the PCI Hot-Plug LED Board.
5. Attach the non-hot plug PCI adapter board cover to the chassis and secure
it with the screw.
6. Close the rear part of the top cover and secure it by tightening the two
thumbscrews in the back.
7. Install the power cords.
8. Push the server back into the equipment rack.
9. Power-on the system.
10. Turn on all peripheral devices connected to the system that you shut down
during this procedure.
Server Management Boards
93
Advertisement
Table of Contents
Troubleshooting
