Removing Dimms - HP Integrity rx4610 User Manual
Hp server rx4610 user guide
Hide thumbs
Also See for Integrity rx4610:
- User manual (201 pages) ,
- Service manual (147 pages) ,
- Installation manual (16 pages)
Table of Contents
Advertisement
Chapter 5
6.
Remove the DIMM from its antistatic package. Align the two notches in
the bottom edge of the DIMM with the keyed socket on the memory
board.
1
2
7. Insert the bottom edge of the DIMM into the socket and press down firmly
until the DIMM is seated correctly.
8. Push the plastic ejector levers on the socket ends to the upright position.
Repeat the DIMM installation steps for each DIMM you wish to install.
Removing DIMMs
You may need to remove a DIMM module to downsize your memory
configuration or to replace a defective DIMM.
1. If the system is already installed and working, power down the system.
Refer to Chapter 1, "Controls, Ports, and Indicators."
WARNING
The power supply will continue to provide standby current to
the HP Server until the power cable is disconnected.
2. Disconnect the power cables and all external cables.
If necessary, label each one to support re-assembly.
3. Remove the top cover from the HP Server.
Refer to Chapter 2, "Opening and Closing the HP Server."
50
DIMM 1
DIMM 2
DIMM 9
DIMM 10
DIMM 17
DIMM 18
DIMM 25
DIMM 26
DIMM 32
DIMM 31
DIMM 24
DIMM 23
DIMM 16
DIMM 15
DIMM 8
DIMM 7
Figure 5-5. DIMM Installation Sequence
Installing Additional Memory
DIMM 5
DIMM 6
DIMM 13
DIMM 14
DIMM 21
DIMM 22
DIMM 29
DIMM 30
DIMM 28
DIMM 27
DIMM 20
DIMM 19
DIMM 12
DIMM 11
4
DIMM 4
DIMM 3
3
Advertisement
Table of Contents
Troubleshooting
