Opening And Closing The Hp Netserver; Introduction; Removing The Front Bezel - HP D5970A - NetServer - LCII User Manual
Hp netserver lp 2000r (1.13, 1.26 & 1.40 ghz) user guide
Hide thumbs
Also See for D5970A - NetServer - LCII:
- Installation manual (203 pages) ,
- Installation and configuration manual (177 pages) ,
- Installation and user manual (174 pages)
Table of Contents
Advertisement
2 Opening and Closing the HP
Netserver
Introduction
This chapter describes how to the remove the front bezel, top cover, and air flow
guide from the HP Netserver LP 2000r.
WARNING
Removing the Front Bezel
You need to remove the front bezel in order to install mass storage devices or
media. You do not need to turn off power to remove the front bezel.
1. Hold the bezel at the opening in the center and pull towards you to release the
top edge of the bezel.
The bezel rests on two pins and is held in place by spring latches at the top. It
rotates down to an 80° angle.
2. Lift the bezel out toward you to remove it from the chassis. See Figure 2-1.
Before removing the cover, always disconnect the power cord
and unplug cables. Disconnect the power cord to avoid
exposure to high energy levels that may cause burns when
parts are short-circuited by metal objects such as tools or
jewelry. Disconnect cables to avoid exposure to shock hazard.
9
Advertisement
Table of Contents
Troubleshooting
