Siemens SINUMERIK 840Di sl Programming Manual page 381
Hide thumbs
Also See for SINUMERIK 840Di sl:
- Commissioning manual (632 pages) ,
- Operating manual (470 pages) ,
- Function manual (274 pages)
Table of Contents
Advertisement
G462
If no intersection is possible between the last TRC block and a preceding block, a straight
line is inserted, on retraction with G462 (initial setting), at the end point of the last block with
tool radius compensation (the block is extended by its end tangent).
The search for the intersection is then identical to the procedure for G461.
Retraction behavior with G462 (see example)
With G462, the corner generated by N10 and N20 in the example program is not machined
to the full extent actually possible with the tool used. However, this behavior may be
necessary if the part contour (as distinct from the programmed contour), to the left of N20 in
the example, is not permitted to be violated even with y values greater than 10 mm.
Corner behavior with KONT
If KONT is active (travel round contour at start or end point), the behavior differs according to
whether the end point is in front of or behind the contour.
• End point in front of contour
• Endpoint behind the contour
Fundamentals
Programming Manual, 11/2006, 6FC5398-1BP10-2BA0
If the end point is in front of the contour, the retraction behavior is the same as with
NORM. This property does not change even if the last contour block for G451 is extended
with a straight line or a circle.Additional circumnavigation strategies to avoid a contour
violation in the vicinity of the contour end point are therefore not required.
If the end point is behind the contour, a circle or straight line is always inserted depending
on G450/G451. In this case, G460-462 has no effect. If the last traversing block in this
situation has no intersection with a preceding block, an intersection with the inserted
contour element or with the straight line of the end point of the bypass circle to the
programmed endpoint can result.
If the inserted contour element is a circle (G450), and this forms an interface with the
preceding block, this is equal to the interface that would occur with NORM and G461. In
general, however, a remaining section of the circle still has to be traversed. For the linear
part of the retraction block, no further calculation of intersection is required.
In the second case, if no interface of the inserted contour element with the preceding
blocks is found, the intersection between the retraction straight line and a preceding block
is traversed.
Therefore, a behavior that deviates from G460 can only occur with active G461 or G462
either if NORM is active or the behavior with KONT is geometrically identical to that with
NORM.
8.11 Smooth approach and retraction
Tool offsets
381
- Quick Links:
- Tool Offsets
Hide quick links:
Advertisement
Chapters
Table of Contents
