F7: System Handling; System Handling - Siemens SIMATIC S5 Manual
Hide thumbs
Also See for SIMATIC S5:
- Manual (360 pages) ,
- Equipment manual (197 pages) ,
- Operating instructions manual (43 pages)
Table of Contents
Advertisement
S5-115F Manual
1.1.7
F7: System Handling
Press softkey F7 to display the "System Handling" menu ( Figure 1-14).
System Handling
F1
CONF DIR
F2
DEL DB
F3
TRAN/LOAD : Transfer/Load
F4
PRINT
F5
PRG-DAT
F6
F7
AUX
F8
RETURN
F1
BLCK DIR
DEL DB
In this menu you can
•
Delete, transfer or load configuration data blocks.
•
Display the directory of the configuration data blocks on a peripheral device of your choice.
•
Print out configuration data blocks for documentation purposes.
Note
The functions can only be implemented if DB 1 is available. This data block is required
to differentiate between configuration DBs and "normal" DBs.
Since COM 115F works with the S5-DOS operating system, a program file must be selected when
accessing the hard disk or diskettes.
This is done with softkey F5. With the exception of the "TRANSFER TO EPROM" function, the
possible operating functions are concerned only with configuration data blocks, since only these
are relevant for configuring an S5-115F. The individual softkey functions are described in more
detail in the following.
EWA 4NEB 811 6149-02
PROGRAM FILE: A:@@@@@@ST.S5D
: Configuration DB directory
: Delete DB
: Print
: Change program file names
:
: Call STEP 5 auxiliary functions
: Return to previous menu
F2
F3
F4
TRAN/LOAD
PRINT
Figure 1-14. System Handling
Configuring with COM 115F
COM 115F / PDC15
F5
F6
F7
PRG FILE
AUX
F8
RETURN
1-23
Advertisement
Table of Contents
