Siemens SIMATIC S5 Manual page 295
Hide thumbs
Also See for SIMATIC S5:
- Manual (360 pages) ,
- Equipment manual (197 pages) ,
- Operating instructions manual (43 pages)
Table of Contents
Advertisement
S5-115F Manual
Error
Con-
Error Message Text
Identi-
sec.
fier
No.
Progr.
33
04
Error during AI module test:
I/O module error
Additional info. 1:
AI word No.
Additional info. 2:
CH AQ word No.
Additional info. 3:
CH DQ word No.
EWA 4NEB 811 6149-02
Possible Cause
Error group No. 10
I/O module test individual error
Error group No. 08
I/O error burst
(only in the case of CPU 942-7UF13
with I/O ETV 3 or 4)
DI module test error:
Comparison error when injecting
check value via CH AQ module:
-
AI module defective
-
AQ module defective
-
CH Rel DQ module defective
-
Wiring error
Address of the AI channel in which
the error occurred,
decimal display
Address of the relevant CH AQ
channel,
decimal display
Address of the relevant CH relay DQ
word,
decimal display
PLC Error Messages
Remedy
-
Replace module
-
Replace module
-
Replace module
-
Check wiring
Warm restart in the case of
individual error in signal group
No. 0 (Stop mode):
1. Stop/Run
Warm restart in the case of
individual error in signal group
No. 1 to 28
(passivation):
a) Test mode:
1. POWER OFF/ON
2. Stop/Run
b) Safety mode:
1. OVERALL RESET
Warm restart in the case of error
burst:
1. POWER OFF/ON
2. Stop/Run
This does not cancel passivation.
To do so, see above. Warm
restart in the case of passivation.
B-35
Advertisement
Table of Contents
