Design and method of operation of the S5-95U with DP master interface
4.4
Technical data of the S5-95U
Technical data
4-8
The technical data of the S5-95U with DP master interface is listed in the
table below. General technical data applicable to all versions of the S5-95U is
to be found in the system manual S5-90U/S5-95U Programmable Controller.
Table 4-4 Technical data of the S5-95U with DP master interface
Technical data
Extension of alarm reaction time
Maximum PLC cycle load time
in SINEC L2 DP operation (per
program cycle)
Internal power supply
Input voltage
Current consumption at 24 V
Output voltage
Output current
Short-circuit protection for U1,
U2 (PG)
Short-circuit/overvoltage
protection
for U2 (SINEC L2 DP interface)
Potential isolation
Protection
0.5 ms
0.5 ms
rated: DC 24 V
permissible range: 20 to 30 V
for the PLC: typ. 280 mA
full config. ext. I/O: typ. 1.2 mA
U1 (for ext. I/O): + 9 V
U2 (for PG/SINEC L2 DP interface):
+ 5.2 V
from U1:
1 A
from U2 total:
0.65 A
from U2 for SINEC L2 interface:
0.1 A
yes, electronic
yes, fuse
250 mA, fast-blow
no
class I
ET 200 Distributed I/O System
EWA 4NEB 780 6000-02a