Addressing The Et 200 In Multimaster Mode And/Or Multiprocessor Mode - Siemens SIMATIC S5 Manual
Distributed i/o system
Hide thumbs
Also See for SIMATIC S5:
- Manual (396 pages) ,
- Equipment manual (197 pages) ,
- Operating instructions manual (43 pages)
Table of Contents
Advertisement
9.8 Addressing the ET 200 in multimaster mode and/or
multiprocessor mode
Introduction
This section describes the meanings of the terms mono-master mode,
multimaster mode and multiprocessor mode. The important points for each
mode are also discussed.
Definition: Mono-
Monomaster mode means that there is one master in a host connected to the
master mode
bus. There are no other masters operating on the bus.
Figure 9-4
ET 200 Distributed I/O System
EWA 4NEB 780 6000-02a
IM 308-C – addressing, diagnostics and use of the FB IM308C
Section
9.8.1
Multimaster mode
9.8.2
Multiprocessor mode
Host system 1
IM 308-C No. 1
Slave No. 10
Monomaster mode
Topic
Master system 1
Slave No. 11
Page
9-40
9-41
9
9-39
- Quick Links:
- IM 308-C Master Interface
Hide quick links:
Advertisement
Table of Contents
